![]() At this time, the red status indicator lights up, indicating that the dosingpump is connected to the cloud, and the user has also completed the binding with the dosingpump.Ī. Click “Start using” in the interface to enter the device list interface. (The device does not support 5G Wi-Fi, and cannot use 5G Wi-Fi hotspot) Enter the Wi-Fi password, be careful not to enter the wrong password, click "Next" to enter the device networking operation ĥ.If the indicator light continues to flash rapidly (configure network by router), select the "The red light is flashing fast and continuously" icon on the App interface, click the "Next" button, and wait for the network configuration to be completed.Ħ.If the indicator is flashing slowly at a frequency of on for 0.2 seconds and off for 2 seconds (configure network by AP), select the "The red light is flashing slowly and intermittently" icon on the App interface, click the "Next" button, and complete the network configuration according to the interface prompts. Make sure that the mobile phone connection requires Wi-Fi with the network, and ensure that the Wi-Fi can connect to the external network. Open the App, click the “+” button in the upper right corner of the device to add the device, enter the Add Device interface, select “Kamoer_F4 PRO” in the list of supported devices and click to enter At this time, you need to use the App to connect the dosing pump to the cloud through the wireless router. Connect the dosing pump to the cloudĪfter the dosing pump is turned on for the first time, the status indicator (red light) flashes slowly. This chapter focuses on how to use the App to control the F4 PRO dosing pump. Refer to the component connection chapter. Please check carefully that the inlet and outlet connections are in the correct direction.The inlet pipe should be as short as possible, and the outlet pipe should be suspended above the vessel.In order to avoid siphoning and reflow, the dosing pump should be placed in a reasonable position to ensure that the height difference between the inlet and the outlet is within 0.5 m. ![]() When the difference between the inlet port and the outlet port is too large, siphoning or reflow may occur. The dosing pump is a self-priming pump.Slowly flashing(on for 2 seconds and off for 2 seconds) Slowly flashing(on for 0.2 seconds and off for 2 seconds) When the router turns on AP isolation, this mode cannot be used, and you need to switch to AP network configuration mode If any defects are found during the unpacking process, please contact the manufacturer immediately.Ĭonfigure network by router. After opening the packing box, refer to the packing list in the appendix to confirm that all parts are not missing and check for visible damage. ![]()
0 Comments
Leave a Reply. |